Exact same experience that I had.
----- Original Message -----
From <DLancer7676 at cs.com>
To: <cfchrist@earthlink.net>; <wolfbj@prodigy.net>;
<spridgets@autox.team.net>
Sent: Sunday, May 25, 2003 12:38 PM
Subject: Re: Roller bearings HELP!
> In a message dated 5/25/03 9:06:37 AM Pacific Daylight Time,
> cfchrist@earthlink.net writes:
>
>
> > they were a drop in installation
>
> Yeah--they dropped into the wheel pretty well. Good fit. Slid on the
spindle
> and sat very well. But there is only one cotter pin hole and the nut
would
> not reach it, even after serious grinding on the nut. And yes. everything
was
> seated. Just would not work. Course the damned things were made in China
and
> Japan respectively (shut up Frank!). But they were the same width as the
ball
> bearings (I checked).
>
> --David C.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|