Hi Jon,
I think you'll find this is really a distance piece rather than a crush
spacer/piece. Usually there are some shims by it, some spacer shims still
available to get the correct tightness on the pinion nut. Just use the piece
again, properly shimmed.
Later, Paul A
jon paschke wrote:
> In case no one is interested if it isn't about cats.......
>
> I'm rebuilding the rear end / differential / third member on my Midget and
> was wondering if the crush spacer is available anywhere? If not what have
> you done to get around this when it is crushed too much?
> Thanks in advance,
> Jon
> SoCa
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|