Peter,
Is it possible to get new seals for the shuttle? I have seen the switches
leak before with the shuttle in the middle. That must mean the seals have a
breach.
Gerard
At 5:27 PM -0600 12/13/02, Peter C. wrote:
>The PWDA shuttle should be centered, at that time there will be no fluid or
>pressure at the switch hole. Look for the notch in the shuttle piston. That
>is where the switch probe goes, and when the shuttle goes off center, the
>probe is depressed, and the light comes on.
> If you remove the shuttle piston, then there would be fluid
>pressure at the switch which will NOT hold pressure.
> Note to all, if you think your switch is leaking, since there
>shouldn't be pressure there, the shuttle piston is bypassing.
> Good luck.
> Gotta go. Be safe.
> peter C
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|