I think these came off a Metropolitan the ratio was 4.55, I guess I'll wait
and use silicone if it leaks. The rear end looks like an early one with
single sided brake wheel cylinder and both sides were the same. Really no
grove in either hub
Jon,
>
> Personally never seen one without a groove. Any chance it was cleverly
> concealed by a snug fitting paper gasket?
>
> Gerard
>
> At 9:18 AM -0800 2/21/02, Jon Paschke wrote:
> >Hi
> >Well I determined I needed a different hub as the bearing was slipping. I
> >dug through parts and found a serviceable one and installed a new bearing
> >and seal. Everything installed perfectly until I got to the O ring. In
this
> >hub there is no groove for it. Is this an early hub? Was this used
somewhere
> >else and no O ring specked? I proceeded with no O ring and now I hope it
> >won't leak.
> >Jon
> >73 Midget
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|