It takes a little practice but I have used it with great success on both
brakes and clutch. The important thing is to only crack the bleed screw a
small amount. It will leak a little air around the bleed screw threads.
These will be very small bubbles and will look entirely different than the
air in the lines. I would pump up the mity vac to draw a vacuum and then
crack the bleed screw, when the gauge is about out of suction I would close
the screw and start again. Keep at it, it was always better than yelling at
my wife.
Mark
Nashville
| I tried to bleed my brakes today, using my new Mityvac for the first time
| ever.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/cgi-bin/wilma/spridgets
|