spridgets
[Top] [All Lists]

Re: Carb part description

To: "Bill Mantz" <bmantz@roanoke.infi.net>, "Spridgets" <spridgets@autox.team.net>
Subject: Re: Carb part description
Date: Wed, 22 Aug 2001 19:58:12 -0500
Bill,
         Those rubber things are not seals, but rather mounts. Moss calls 
them adapters. They actually position the angle of the float bowl relative 
to the manifold. Different applications of HS carbs would have different 
"adapters" depending on the angle of the manifold since the float bowl lid 
must always be parallel to the ground. Different adapters have that 
positioning tab in different clock positions. All HS carbs have them.
         Anyway, you only need 1 per carb, if at all, as they do not seal 
anything and are remarkably re-useable.
         I hope I understood your question correctly.
         Peter C
===
At 07:22 PM 8/22/2001, Bill Mantz wrote:
>I am semi-rebuliding(cleaning and replacing gaskets and seals) the HS-2
>carbs on the 71 Midget.
>The rubber seal between the float chamber and carb body needs replacing. The
>only thing the M%^$ catalog shows is a front and rear adapter for 8.75 each
>(35 bucks for 4 rubber seal, according to the sales person, the "front
>adapter goes on the front carb and the rear adapter goes on the rear carb" -
>sigh. My manuals don't show this piece at all. Are these the correct
>parts?????



<Prev in Thread] Current Thread [Next in Thread>