Usually with 4 bolts, nuts, and lock washers per end.
On 5/12/01 2:21 AM, "Maclean Mike" <macleans@earthlink.net> wrote:
> What's the best method to replace the driveshaft after pulling it out to
> R&R the u-joint? That is, with the engine and transmission in situ, as
> the manuals say.
> Mike MacLean-60 Sprite
>
>
Sorry ;-)
Larry
Larry Macy
78 Midget
Keep your top down and your chin up.
Larry B. Macy, Ph.D.
macy@bblmail.psycha.upenn.edu
System Manager/Administrator
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 10 Gates
Philadelphia, PA 19104
Ask a question and you're a fool for three minutes; do not ask a question
and you're a fool for the rest of your life.
|