APT www.aptfast.com sells HS4 manifolds for the A-series. Part number SUA4-2
is the one for Spridgets (carb sits at a 20 degree angle like a stock
manifold.) at $179 it's pricey, but they maintain that it flows much better
than a B manifold. (this not at all like the manifold on Dan's car)
No provision for vacuum take-off however.
Phil Vanner
61 Midget
-----Original Message-----
Hello Dan,
Monday, April 09, 2001, 1:13:45 PM, you wrote:
DD> No bubbles needed as long as you use the correct
DD> manifold rather than butchering a B intake.
In all fairness ours are for a 1500 and uses the stock manifold. Tim
modified a B manifold to fit a 1275. Not sure about how high it
sticks up.
--
Best regards,
Bill mailto:w.gilroy@verizon.net
///
/// (If they are dupes, this trailer may also catch them.)
|