Hello DLancer7676,
Sunday, April 08, 2001, 6:43:35 PM, you wrote:
Dcc> In a message dated 4/5/2001 10:18:54 PM Eastern Daylight Time,
Dcc> bquietroy@neo.rr.com writes:
>> . I took a set of HS4's from an MGB and adapted the intake and heat
>> shield so they can be mounted on your LBC.
Dcc> Roy:
Dcc> I have a dissolving 1967 MGBGT sitting in my backyard with a perfectly
good
Dcc> set of rebuildable 1 1/2" SUs on the original intake manifold. Is it
Dcc> possible to adapt that intake manifold to fit the 1275 or the 1500?
Dave,
I bought a set of 1 1/2" SUs and a UK spec manifold from a guy, I can
dig out his number. They fit except you need to make a slight dent in
the brace that is welded to the inner fender. A couple of minutes
with a ball peen hammer and it looks almost stock. The hard thing to
find in the states is a 1500cc UK spec manifold. I am about 1/2 done
fitting the damn things, I just have been real busy. Both Dan and
Mike have already done this with good results.
--
Best regards,
Bill mailto:w.gilroy@verizon.net
///
/// (If they are dupes, this trailer may also catch them.)
|