When you cut off the anti-foul adapter, you determine how far it sticks in
by how short you cut of the adapter. On a stock Spridget exhaust pip, there
is no way you can have the whole sensor stick in, it would reduce take up
too much of the flow area. I have about half of the sensor sticking into
the pipe.
Ulix
----- Original Message -----
From "Jeff Boatright" <jboatri at emory.edu>
To: <spridgets@autox.team.net>
Sent: Thursday, September 14, 2000 7:22 AM
Subject: Re: SU Needle selection and Air/Fuel Gauges
> Lots of info about oxygen sensors at:
>
> http://www.howstuffworks.com/question257.htm
>
> After looking at the senor photos, it seems to me that you would not
> want one of those things installed permanently as there is quite a
> bit of sensor sticking out in the exhaust stream.
>
> _____________________________________________________________
> Jeffrey H. Boatright, PhD
> Assistant Professor, Emory Eye Center, Atlanta, GA, USA
> Senior Editor, Molecular Vision, http://www.molvis.org/molvis
> mailto:jboatri@emory.edu
>
>
|