I don't know that I would necessarily want mine in there all the time, but the
sensor section (that sticks into the pipe), at least on my 3 wire Bisch unit,
is a little shy of 3/4 of an inch deep, and 1/2 inch in diameter. Not too
large. At least not enough to really worry about it. Performance shouldn't be
affected too much.
Mike
Jeff Boatright <jboatri@emory.edu> wrote:
> Lots of info about oxygen sensors at:
http://www.howstuffworks.com/question257.htm
After looking at the senor photos, it seems to me that you would not
want one of those things installed permanently as there is quite a
bit of sensor sticking out in the exhaust stream.
_____________________________________________________________
Jeffrey H. Boatright, PhD
Assistant Professor, Emory Eye Center, Atlanta, GA, USA
Senior Editor, Molecular Vision, http://www.molvis.org/molvis
mailto:jboatri@emory.edu
|