Daniel -
I just stepped put of the shower, so I'll handle it.
Drew -
Check the archives at:
http://www.listquest.com/lq/search.html?ln=spridgets
This was, shall we say, thoroughly discussed. Read the archive and make
up your own mind.
Daniel1312@aol.com wrote:
>
> There is a serious issue that may well involve firearms and silicone brake
> fluid - everyone take a cold shower before replying. <g>
>
> Daniel1312
>
> In a message dated 25/08/00 22:53:39 GMT Daylight Time,
> Andrew.Griffith@ReadRite.com writes:
>
> << I'm sure this has been mentioned before, but where can I get shims to fit
> the wheel bearing in the front hubs?
> Even though I'm converting to roller bearing... I was advised (for added
> strength and support) to continue using the factory center spacer, between
> the inner and outer bearings.
> Thanks,
> -Drew in San Jose
> >>
|