There is a serious issue that may well involve firearms and silicone brake
fluid - everyone take a cold shower before replying. <g>
Daniel1312
In a message dated 25/08/00 22:53:39 GMT Daylight Time,
Andrew.Griffith@ReadRite.com writes:
<< I'm sure this has been mentioned before, but where can I get shims to fit
the wheel bearing in the front hubs?
Even though I'm converting to roller bearing... I was advised (for added
strength and support) to continue using the factory center spacer, between
the inner and outer bearings.
Thanks,
-Drew in San Jose
>>
|