In a message dated 06/25/2000 12:27:11 AM Mountain Daylight Time,
ulix@u.washington.edu writes:
> Is it feasible to change the bearing? Do I need special tools? Should
> I let a professional handle it?
>
> Thanks,
> Ulix
Ulix, it been over thirty years since I've done one but I seem to remember
removal was punch it out with a small drift, or prise it out with the middle
sized Craftsman screwdriver.
Of course, chuck can probaly tell you haw to do this in the dark, in the
rain, in a foxhole, with nail scissors....;-)
Bearing should be standard size.
RH
|