And....... loose shock bolts.
Peter C
At 07:29 PM 4/17/2000 , Frank Clarici wrote:
>wizardz@maxinter.net wrote:
>>
>> I'm about to open up my rear end to resolve the 'clonk'
>>
>> QUESTION: the axles must come out to remove the pumpkin
>> from the diff case right? How much of the hub/wheel/backplate do I
>> have to take apart just to back the axles out enough to remove diff assy?
>
>Check the drive shaft bolts first. I had them come loose and it makes a
>clunk.
>Also check you leaf springs for a crack, it clunks too.
>Pulling the axle is easy, remove the brake drum, remove the axle set
>screw and pull it out. You may have to pry it off the rubber "O" ring
>with a screw driver.
>Be sure to replace the O ring and paper gasket. Also watch for gear oil
>dripping out when the axle comes out.
>
>--
>Frank Clarici
>Toms River, NJ
>Down to only 3 Sprites, 1 Midget and an A40 Farina
>http://www.exit109.com/~spritenut
|