Re: RE: Solid vs. Wire Wheels

[Bkitterer@aol.com]

In a message dated 11/17/99 4:56:08 PM, Andrew.Griffith@ReadRite.com writes:

<< Speaking of rear-ends... Does anybody know how to ID the narrower wire 
wheel
rear-end for (1/4 elliptical springs)from the standard one? Any suggestions? 
>>

Drew,

Just use a tape measure.  You can check between the brake backing plate 
flanges.  If the differential and axles or out measure through the center for 
over all length.

Bob and Annice
1960 Sprite (Mk IV in disguise)
1966 Sprite Mk III (Trevor) in progress