Daniel,
I'm not sure of the answer to your specific question, but there is also a
dished springwasher that should be used before the fastener.
Gerard
At 12:22 PM -0500 11/7/99, Daniel1312@aol.com wrote:
>Hi List,
>
>On the rear brakes the slave cylinder is held in position by a stupid clip
>called an E clip. When I ran standard rear brakes I replaced the E clip with
>a circlip which I found was much easier to fit.
>
>However, I seem to recall that there is some argument against using a circlip
>instead of an E clip - something to do with allowing a degree of 'float' or
>'freeplay' of the slave. Anyone know anymore about this?
>
>Daniel
If you can stay calm, while all around you is chaos... then you
probably haven't completely understood the seriousness of the situation.
G G Gerard Chateauvieux
E A
R R pixelsmith@gerardsgarage.com
A A
R G Pixelsmith on Duty
D E
S http://www.gerardsgarage.com
|