I don't think these are available anymore. I've looked for them and haven't
had much luck. If you have a tap and die set, you can always rethread the
stud to the next smaller size. Hope this helps!
Greg Gowins
'69 Sprite
Dublin, CA
-----Original Message-----
From: Paul A. Dolloff, Ph.D. <pauld@ekpc.com>
To: spridgets@autox.team.net <spridgets@autox.team.net>
Date: Tuesday, October 12, 1999 12:06 PM
Subject: Starter solenoid
>List,
>
>While replacing a bad positive battery lead I stripped the threads on the
>starter solenoid. Is this a simple threaded rod that can be replaced?
>
>The solenoid that I have is not an original. It has a push button that
makes
>contact as if the ignition switch were turned to the start position. It
was
>great to have when adjusting the values. What car did this come from and
>can I get another if the old one can't be repaired?
>
>Thanks,
>Paul
>
>--------------------------------------------------------------
>Paul A. Dolloff, Ph.D.
>Lexington, KY
>606/744-4812 ext. 389
>'66 A/H Sprite MK III: HAN8L-55641
>'66 A/H Sprite MK III: HAN8L-59017
>'69 A/H Sprite MK IV: Parts car
>--------------------------------------------------------------
>
|