| To: | Lancer7676@aol.com, Metallian6@aol.com, spridgets@autox.team.net |
|---|---|
| Subject: | Re: Checking bearing specs |
| From: | Ronsoave@aol.com |
| Date: | Thu, 8 Apr 1999 21:04:38 EDT |
| Reply-to: | Ronsoave@aol.com |
| Sender: | owner-spridgets@autox.team.net |
In a message dated 99-04-08 20:40:36 EDT, Lancer7676@aol.com writes: > And it still is probably the best way to check > the tolerances as far as I know. Assemble the bearings in their caps. Tighten to specified torque. Use bore micrometer to measure ID. Use outer mic to get diameters of the crank journals. Subtract. It's the best way, if you've got the tools. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: new subscriber, Valentine |
|---|---|
| Next by Date: | Re: More windshield questions, Ronsoave |
| Previous by Thread: | Re: Checking bearing specs, Lancer7676 |
| Next by Thread: | Bugeyes on TV! SpeedVision..., Toby Atwater |
| Indexes: | [Date] [Thread] [Top] [All Lists] |