In a message dated 4/8/99 4:57:48 PM Central Daylight Time,
Metallian6@aol.com writes:
<< When I put the rod and main bearings back in my 948cc how do I check the
clearance? When I built a 327 for my old '76 Camaro I used plastie gage. >>
Yep
<<But at that time I was taking auto shop. I don't have any plastie gage on
hand. >>
Guess the teacher didn't teach anything!! Go to any *decent* auto
parts.machine
shop - they sell it!!
<< Is there another way cause I don't want to go through all this work and
have
anything being a little off and having to do this over again. >>
You can always let the machine shop do the work. Added plus - WARRENTY .
<<Any comments on
this would be appreciated.>>
And there you have them!!<G>
Cheers..............
Ed
|