This has come up before and I seem to remember that the consensus was that
the rods for the 3/4 and the 7/8 MC were the same length. I was sorting out
a box of brake parts containing four Sprite master cylinders and all of
their bits and pieces, three 7/8's and one 3/4 cylinder. Four sets of push
rods, three sets 3'' long and one set 2 1/2' inch long. This would seem to
indicate that the 3/4 cylinder has shorter rods.
Anyone have either type laying around where you could measure the rods. I
measured just the smooth portion of the rod, not the wrench fitting and the
threads.
Comments appreciated.
Larry Miller (bugiiis@yahoo.com or millerls@msn.com)
59 Bugeye (Starting to look like a Bugeye)
59 Bugeye "BUGIIIS" (Undergoing a body transplant)
78 911 SC (Faster than a Bugeye but not as much fun)
Home Page http://members.xoom.com/bugiiis
|