| To: | birdman@lightspeed.net |
|---|---|
| Subject: | Re: King Pin Shims? & Wheel Bearings? |
| From: | pasgeirsson@juno.com (Paul A Asgeirsson) |
| Date: | Tue, 10 Nov 1998 10:02:45 EST |
| Cc: | jboatri@emory.edu, pasgeirsson@juno.com, spridgets@Autox.Team.Net |
| References: | <004101be0c68$e4ae1aa0$f845d8cc@bonz> |
| Reply-to: | pasgeirsson@juno.com (Paul A Asgeirsson) |
| Sender: | owner-spridgets@Autox.Team.Net |
Those torque suggestions in the manual are for when the spacer is fitted. Don't use them without the spacer. Bearings may last a day with that torque and no spacer. The Morris manual says 70 lbs ft! Paul PAsgeirsson@juno.com On Mon, 9 Nov 1998 21:10:12 -0800 "Jon Paschke" <birdman@lightspeed.net> writes: >my Haynes says 46 for disks and 55-65 lbf ft for drums > >>But doesn't the manual call for 46 lb-ft torgue for the castle nut? >> >>Jeff >> >> >Hi Listers, >>> >>>This may be a little late, but I would like to jump into the fray >with my >>>experience on wheel bearing spacers and shims... >> >>snip >> > > |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Clutch problem - not disengaging, Peter |
|---|---|
| Next by Date: | Re: Wheel bearing Shims, Peter |
| Previous by Thread: | Re: King Pin Shims? & Wheel Bearings?, Jon Paschke |
| Next by Thread: | Veteran's Day, Richard D Arnold |
| Indexes: | [Date] [Thread] [Top] [All Lists] |