everyone,
if i remember correctly, all jets for s.u. are the same size.please correct me
if that is not the case.
the problem i have is that the rear carb will not run lean...as a matter of
fact even with the jet all the way up, it satill runs rich. the needle is
correct #gg and the float level is also ok (7/16" rod will barely pass under
with the needle shut). the only other item i can think of it a worn out jet.
what do you think....any other ideas????
the front carb has the same needle size and responds to adjustment
beautifully. both carb have just been rebuilt.
also, my blinker is very slow but works, in the front bulbs does the larger
filament correspond to the signal lights or is it the smaller filament?
thanks
alex
|