Elliott, Patrick wrote:
> I rebuilt my 1275 and have finally got it into the car. Before I
> attempt to run it , I would like to turn it over , build up some oil
> pressure, and generally make sure nothing is going to break.
> Question #1. Do I have to "prime" the oil system in any way?
Yes.remove the oil pipe (from filter to block) at the block and put a few onces
of oil down there,
this primes the oil pump.
> Question #2. How long will it have to turn over before I get any oil
> flow out of the pressure gauge fitting?
When primed, about 5 seconds.
> Question #3. When I rebuilt it, I filled the top end of the cylinder
> with oil to protect them while I got the car ready to except the
> engine. Would it behoove me to flush these out
> with gas or diesel ? or just let it burn out?
Pull plugs, spin engine, stand aside! this will blow out any oil.
> Question #4 Does anyone have a Starter switch from a 948 ?
Key or solenoid?
Frank
|