For a more "finished" look, sand down the edges you cut to a smooth finish,
then carefully move up and down the edge with a propane torch. Done properly
(practise on a scrap piece... too hot and it melts), you'll achieve a glossy
smooth finished edge.
WST
Team Thicko
Frank Clarici wrote:
> David Ramsey wrote:
> >
> > I was wondering if any of you have replaced the plexiglass in your
>side curtains? The two kits I'm looking at are the VB 00-182, 181 @ 32.95
>each and minimania AHA5800/kit @99.95 is there any difference between the two?
>How hard are they to install?
> > Crash
>
> Crash
>
> The plexi is a siple replacement.
> Buy it just about anywhere, cut it to fit with a jig saw and pop it in the
> track.
> The whole job takes about an hour and should cost about $10.
> A little more if you use Lexan (bullet proof plexi) very pliable too.
> --
> Frank Clarici
> Seeing all of you at Sprite Rush 98
> For more info on Sprite Rush, the 40th anniversery of the Sprite
> Check out my home page http://www.exit109.com/~spritenut
> ------------------------------------------------------------------
|