Did you have the clutch taken apart? If so, did you use the proper alignment
tool to get the clutch disk centered when you reassembled it?
In my experience, trying to center it by eye almost never works.
Doug Braun
'72 Spit
--- On Fri, 10/2/09, ccullen16@cogeco.ca <ccullen16@cogeco.ca> wrote:
> From: ccullen16@cogeco.ca <ccullen16@cogeco.ca>
> Subject: Re: [Spits] Transmission installation
> To: Spitfires@autox.team.net
> Date: Friday, October 2, 2009, 11:38 AM
> Thanks for the advice Jim (Michael
> and James too). I kind of thought that I would need to back
> it out. I just wasn't
> sure if I would get any better results the second time. I
> have jacked up the block and the tranny and did play around
> with the height last night when attempting the job. I
> didn't back out the tranny though thinking that once I had
> the
> tranny on the guide dowel and the studs I had achieved
> success. I will try again keeping advice in mind.
>
> Thanks,
>
> Jim Cullen
> 74 Spitfire
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
http://www.team.net/archive
|