How about a veneer door topping? I took a 6 inch wide strip of matching
left over veneer from my dashboard project and let it soak overnight in warm
water. The next day, I carefully inserted the veneer between the door and
the chrome window strip, and curved the veneer downward, holding the lower
edge in place with the inner door panel.
I let it dry thoroughly for a couple of days. Then I carefully trimmed the
veneer ends to fit the top of the door. Because the end of the door nearest
the door handle has several compound curves, I trimmed the veneer to fit,
and painted the door black.
Glued the veneer down and with a coat of urethane, it looks pretty good!
-----Original Message-----
From: spitfires-bounces+parrotthead01=comcast.net@autox.team.net
[mailto:spitfires-bounces+parrotthead01=comcast.net@autox.team.net] On
Behalf Of mark.jones@exxonmobil.com
Sent: Tuesday, June 17, 2008 11:04 AM
To: spitfires@autox.team.net
Subject: [Spits] Vinyl door capping
I'm busy reassembling my Spitfire; would be nice to have it back on the
road this month.
I bought the vinyl door capping but found the ones I received were about an
1" too short from front to back. Anyone else found this?
Also, has anyone tried using a piece of vinyl to make their own? It
actually looks like it should be fairly easy to make.
Mark
80 Spitfire 1500
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
http://www.team.net/archive
|