Richard,
Thanks.
I've had a couple of: "No, won't work."
The reason I ask is that I found a pair of webers on ebay that were bundled
with a manifold.
Best regards
Ronny
-----Original Message-----
From: Gosling, Richard B [mailto:Richard.Gosling@atkinsglobal.com]
Sent: den 27 oktober 2005 12:20
To: Ronny Hortlund; spitfires@autox.team.net
Subject: RE: Inlet manifold for a Triumph 4A suitable for a Triumph 1300
engine?
Ronny,
I couldn't say for sure, but I seriously doubt it. The engine used in the
TR4A wasn't just a different capacity, it was part of a totally different
engine range to that used in the Spitfire. A TR4A manifold is more likely
to fit a Ferguson tractor than a Mk1 Spit!
Richard
This email and any attached files are confidential and copyright protected. If
you are not the addressee, any dissemination of this communication is strictly
prohibited. Unless otherwise expressly agreed in writing, nothing stated in
this communication shall be legally binding.
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|