FW: "Locate engine in gearbox" huhh!

["Nick Moseley" <nmoseley@dccnet.com>]

That is how the manual states one should re-install an engine into the car
when one has been removed leaving the gearbox in the car.
Just spent an aggravating afternoon trying to do just that.

Engine is on hoist, at an angle. Transmission is resting on a floor jack, at
_almost_ the same angle. I say almost as the two do not seem to want to wed.

Any tricks, tips, suggestions, or shall I just continue to wriggle and push
until the magic moment?

Sorry for the cross post

NASS 278

76-80(1) Spits

Delta B.C.