..."I have the gearbox in neutral so that i can spin the input shaft to met
up with the
clutch plate splines, but no dice there"...
It might be better to have the gearbox engaged - that way you can turn the
output shaft by hand in order to rotate the input shaft until the splines
engage. 4th gear is best - the higher the gear, the slower the input shaft
will turn relative to your efforts to turn the output shaft.
Good luck!
Richard Gosling
This email and any attached files are confidential and copyright protected.
If you are not the addressee, any dissemination of this communication is
strictly prohibited. Unless otherwise expressly agreed in writing, nothing
stated in this communication shall be legally binding.
|