----- Original Message -----
From: <Jdgar0649@aol.com>
> Even easier and cheaper to use a floor press.
This is a good way to destroy hubs - they need to be supported around the
entire circumference to prevent distortion. I don't know what the referenced
hub puller is like, but I presume it is similar in concept at least to the
original Churchill tool. If that's the case then it's well worth the
investment.
For the record, new hubs retail in the UK at over 60 pounds - using the wrong
tool is hardly cheap :-)
Cheers,
Bill.
--
Rarebits4classics
.......just what you've been looking for
PO Box 1232
Calne
Wiltshire
SN11 8WA
United Kingdom
http://www.rarebits4classics.co.uk
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|