Well for $40 even... a gentleman on the NASS
list has been selling professionally built (cnc machined)
proper pullers. i think we helped him sell about
30 of the pullers just in the last couple of months.
check there archives at
http://autos.groups.yahoo.com/group/nass/
Paul Tegler
ptegler@cablespeed.com
www.teglerizer.com
----- Original Message -----
From: "Larry Vaughan" <lvaughan@pldi.net>
To: <spitfires@autox.team.net>
Sent: Saturday, May 24, 2003 12:16 AM
Subject: hubpuller
> Hi all,
> I bought some mags for my Spit recently. I had to upgrade the wheel
studs,
> to use the mags. I also had to pull the rear hubs, to get the new studs
in.
> Well I fashioned a puller out of scrap iron and various parts, for about
> $35.00.
> I tried it out today and IT WORKED!
> I used a half inch breaker bar and tightened the puller, then hammered on
> the puller, tightened the puller, then hammered the puller, etc.
> Eight or ten tighten/hammer cycles and I had the hub off, undamaged!
> I have pictures at http://www.ljvaughan.homestead.com/hubs.html
>
> Larry
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|