Thanks for the help so far.
Speaking of needle and springs, would any one like to take a guess which
needles I should try first?
The current condition of my engine is a '74 1500 with 9:1 pistons, .100
milled off the head (should have had the head cc'd but didn't, so I
don't know compression ratio), 3 angle valve job, and a cam with 275
degrees duration and .425" lift. The exhaust is currently stock. I would
like to get the car running with the SUs then put on my Rimmer 4-2-1
header and possibily a Supertrapp I have laying around.
Is there a good source in the USA for springs and needles?
Thanks,
Chris
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|