> -----Original Message-----
> From: sinclair@degenkolb.com
> I am in the process of adding a roll bar to my Spitfire. Presently I
> have
> the MK3 convertible frame that folds behind the seats (and am not very
> happy with it for various reasons). To fit the roll bar I intend to
> replace this with the earlier MK1/2 removeable system, which I still
have
> from a previously owned project car. This will have the added benefit
of
> saving my seats, which presently rub against the frame and are about
to
> develop a couple of nasty tears.
~~CUT
> Also - if anyone has a better idea to achieve the end objective I'm
open
> to suggestions.
Mark,
When I added a roll bar (from MG Mitten, if I remember correctly --wow,
that shows my age :-)) to my Mk3, I found that the top just cleared the
roll bar, but would not fold. I improvised by replacing the screws that
bolted the top frame to the body behind the doors with short studs and
wing nuts. I could quickly spin off the wing nuts and pop the frame off
when I wanted to remove the top. It took slightly longer to unscrew the
2 chromed bolts fastening the back of the convertible top to the car.
After undoing everything, I could lift the frame and top, fold it, and
store it in the trunk. The studs protruded 1" or so and made it easier
to put the top back. The only disadvantage was the nicks in the vinyl
behind the doors from occasional misses when slipping the top and frame
back on.
Just an alternative idea for you.
Thanks,
Larry Griffin
68 Mk3 Spitfire -future project
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|