spitfires
[Top] [All Lists]

Re: Heater Valve Bracket

To: "Jeff McNeal" <jmcneal@ohms.com>, <spitfires@autox.team.net>,
Subject: Re: Heater Valve Bracket
From: Dan Canaan <flinters@picarefy.com>
Date: Tue, 04 Jun 2002 18:38:37 -0700
At 05:53 PM 6/4/02 -0700, Jeff McNeal wrote:
>Thanks Dan, that's very nice!  Your technical drawings are truly 
>awesome.  Hopefully, I can find one from a donor car, but if I have to, I 
>may be able to fabricate one.  It doesn't look overly complex.  I hope!!


Well now, with that compliment I had to go out to the garage and dig 
through my pile of parts and pieces... and I found a bracket still attached 
to a heater valve to take a few photos of for you.

http://jarmac.picarefy.com/spitfire/htr-bracket6.jpg

http://jarmac.picarefy.com/spitfire/htr-bracket5.jpg

http://jarmac.picarefy.com/spitfire/htr-bracket4.jpg

While you *could* probably fabricate this fairly easily out of sheet metal 
and a couple of light tack welds, it would probably be far easier to just 
give me your address so I can send this one I just sandblasted and cleaned 
up to you instead. :)

Spitfire enthusiasts share information and parts to keep our Spits running!

Now I just need to find that elusive fuse box for a Mk III...
---------------------
This message has been sent by Dan Canaan, aka Flinthoof.  All content is 
copyrighted by this individual for better or for worse, especially if there 
is mint involved.  We thank you for your support.  Please give mint to your 
local Mint Cross Center. 

///  spitfires@autox.team.net mailing list
///  or try  http://www.team.net/cgi-bin/majorcool
///  Archives at http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>