In message <11EEFA4B6844D511A0E70008C71E9F018F3A23@ABDEXH01>you write:
>Andre,
>
>If I understand you right, you want to separate the drive-shafts from the
>differential?
>
>In that case, you should remove the bolts that connect the UJ (twisty
>coupling) flange to the differential output flange. You can only slide the
>bolts out when they are at their lowest point in the rotation, as the
>differential gets in the way otherwise!
>
Also, please do not put yourself directly under the drive shaft when
removing the last bolt. The shaft can fall without warning once the
last bolt is off.
Dave |\ | | |
_______________________________________/\ /\ /\_____| \|_____| |____________
Dave Chu \/ \/ | /| | |
Dept. of Elec. & Comp. Eng. |/ | | |
Concordia University Voice:(514)848-3115 Fax:(514)848-2802
1455 de Maisonneuve W. H961 Email:dave@ece.concordia.ca
Montreal, Quebec, Canada H3G 1M8 http://www.ece.concordia.ca/~dave/addr.html
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|