Just about a year ago I replaced the clutch and had some work done on
the tranny. To make a long story short some of the new parts in the
tranny failed so I pulled it out and a friend rebuilt it again. I was
getting ready to put the tranny in and looked at the clutch as I was
figuring out my next move.
I noticed that the fingers on the pressure plate weren't evenly worn
some of them had a fairly deep groove worn in them while others did not.
It doesn't seem like this should happen, but I think my old clutch was
this way when I replaced it last year. Any suggestions on what might
cause this? It seems like it has to be something wrong with the flywheel
or the clutch, but what and how to I check it?
Thanks,
Roger Elliott
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|