Re: Plug welding holes in sheet metal.

["Jeff McNeal" <jmcneal@ohms.com>]

Either copper or aluminum are fine.  I think Eastwood sells flexible copper
pieces for getting behind curved pieces that you're wanting to fill.
  ----- Original Message -----
  From: Bob Harris
  To: Barry Schwartz ; triumphs@autox.team.net
  Cc: spitfires@autox.team.net
  Sent: Friday, March 15, 2002 1:30 PM
  Subject: Re: Plug welding holes in sheet metal.


  Barry,
             I am no welder,but work in a fab shop,and have seen a man
  repairing old tractor headlight buckets that were rusted through. He used
  copper,I believe.
                                                        Hope this helps,
                                                        Bob Harris

///  spitfires@autox.team.net mailing list
///  or try  http://www.team.net/cgi-bin/majorcool