Come on Paul, you can surely tell the difference between heating up the entire
length of a coil spring to collapse it and heating up a few inches when cutting
it. There's no "flip-flop" on my part. Though it certainly is tacky of you to
stick a slur like that in the subject line.
>>> <ptegler@gouldfo.com> 02/13/02 11:44AM >>>
Wait a second Nolan...it was YOU that was advocating
cutting springs with a torch when Joe C. was saying to
..if anything... cut them with a grinder. You stated back then that YOU
used a torch without any problems and continued by going
into this big dissertation about having worked with welding
and metal stress and such.
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
|