Tim,
One more possibility - there is some axial movement of the slave cylinder
possible, to adjust its installation position. Does the slave cylinder need
moving forwards slightly? Was the clamp bolt done up too loosely, allowing
the slave cylinder to move backwards?
Just a thought.
Richard & Daffy
----------------------------------------------------------------------
Important Notice:
The information in this email is confidential and may be legally-privileged.
If you have reason to believe you are not the intended recipient, any
disclosure,
copying, distribution or any action taken or omitted to be taken in reliance on
it is prohibited and may be unlawful and you are requested to contact the sender
urgently and dispose of this email
-----------------------------------------------------------exp.
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
|