Spent the weekend transplanting a set of HS4s into the
75 1500. This is a good used set that I checked for
trottle shaft wear. There was none measurable. It got
dark so I had to stop working. It starts and runs but
sounds like it is missing on a cylinder even though it
is not. The rear carb is pulling well but the forward
one is not doing much. If I richen it up blocking the
air by putting my hand over the intake, it runs well.
I get a little gas back on my hand after about 20
seconds. I've dropped down the jet to about 4 turns
from the top, but it doesn't seem to be doing
anything. Any Ideas out there?
Chris DeStaffany
Get email at your own domain with Yahoo! Mail.
http://personal.mail.yahoo.com/
|