spitfires
[Top] [All Lists]

Re: { NASS } Re: [spitfire-enthusiast] new tool - hub puller

To: <nass@egroups.com>, <spitfire-enthusiast@egroups.com>
Subject: Re: { NASS } Re: [spitfire-enthusiast] new tool - hub puller
From: Paul Tegler <ptegler@cablespeed.com>
Date: Wed, 24 Jan 2001 20:06:35 -0500
Yep.. my first impression as well. (should use a ball
in the bolt end) ... but worked fine without it.
Hence the design of this one... being deep enough to
leave the nut at the end of the threads on the axle
so the hub doesn't fly off.
...but the one on EBay is useless for pulling the carrier
(ie: bearings) off the axle as this one can do.

I'll forward the recommendation to the supplier.
(about the ball end)

Paul Tegler      ptegler@cablespeed.com
www.teglerizer.com

----- Original Message -----
From: "Nolan Penney" <npenney@erols.com>
To: <spitfire-enthusiast@egroups.com>
Cc: <triumphs-owner@autox.team.net>;
<triumphs@autox.team.net>; "CARS Spitfires@Autox. Team. Net
(E-mail)" <spitfires@autox.team.net>; <NASS@egroups.com>
Sent: Wednesday, January 24, 2001 7:22 PM
Subject: { NASS } Re: [spitfire-enthusiast] new tool - hub
and bearing carrier puller for Spits


> Only thing that concerns me is the use of a flat faced
bolt as the
> center pusher.  The original one (there's one on e-bay
right now btw)
> used a ball there.  Gear pullers use a swivel foot.  This
prevents the
> galling action that damages the face of the part being
pushed, the axle
> in this case.  It also reduces the torque required to push
the parts
> apart.
>
> If nothing else, it would be wise to instruct the customer
to apply
> grease to the face of the bolt when using it.
>
> Paul Tegler wrote:
>
> > ...just a preliminary write up .
> > I'm just hosting the info for the source.
> > The complete 'system' is under $100.
> >
http://www.teglerizer.com/triumphstuff/hubtech/index.html
> >
> > I'll be writing up pages describing the entire system
> > and showing photos of the system in use.
> > complete directions for this unit will also be posted.
> >
> > I'm sure this tooling could be slightly redesigned to
> > fit quite a few of our LBC's so we need your input and
> >  comments.
> >
> > thanks
> >
> > Paul Tegler      ptegler@cablespeed.com
> > www.teglerizer.com
>
>
> To subscribe goto:
http://www.egroups.com/list/nass/info.html
>
> To Post a message, send it to: nass@eGroups.com
>
> To Unsubscribe send a blank message to:
nass-unsubscribe@eGroups.com

<Prev in Thread] Current Thread [Next in Thread>
  • Re: { NASS } Re: [spitfire-enthusiast] new tool - hub puller, Paul Tegler <=