I found the overlay covers to be a bit too glossy and
didn't like the feel of them.
My pad only had 2 cracks in it, but most of the vinyl
had become very brittle. It didn't make sense to me
to put new vinyl over the old brittle stuff. I was
afraid any new cracks that formed in the old vinyl
would show through the new cover, so I CAREFULLY
removed the old vinyl off the foam pad and glued a new
cover onto the old foam. Don't peel it like a banana,
you will ruin the foam. Use a putty knife and work at
the glue bond between the foam and vinyl.
I just used automotive grade vinyl and contact cement
and followed the advice given on the VTR page Vic
mentioned.
Hopefully the glue I used will hold better than the
stuff Vic used...
Jason C
GT6
__________________________________________________
Yahoo! Photos - 35mm Quality Prints, Now Get 15 Free!
http://photos.yahoo.com/
|