My Midget 1500 Factory Manual says 0.006" to 0.014" as the crankshaft
endfloat.
Thats for all Midget 1500's
Mike
-----Original Message-----
From: James F. Libecco [mailto:jfl@neoucom.edu]
Sent: Monday, September 18, 2000 12:40 PM
To: Spit
Subject: thrust washers
NEEDED: What is the proper clearance for the thrust washers? I have seen
three specs from .002 through .018. Somewhere a proper number must exist.
I have had to put two new cranks into this car in the past two months and
quite frankly am tired of putting money into this after thrust washer
expulsions.
Any suggestions to save my 76 1500?
This message is for the named person's use only. It may contain
confidential, proprietary or legally privileged information. No
confidentiality or privilege is waived or lost by any mistransmission.
If you receive this message in error, please immediately delete it and all
copies of it from your system, destroy any hard copies of it and notify the
sender. You must not, directly or indirectly, use, disclose, distribute,
print, or copy any part of this message if you are not the intended
recipient. CREDIT SUISSE GROUP and each of its subsidiaries each reserve
the right to monitor all e-mail communications through its networks. Any
views expressed in this message are those of the individual sender, except
where the message states otherwise and the sender is authorised to state
them to be the views of any such entity.
Unless otherwise stated, any pricing information given in this message is
indicative only, is subject to change and does not constitute an offer to
deal at any price quoted.
Any reference to the terms of executed transactions should be treated as
preliminary only and subject to our formal written confirmation.
|