Thanks Patrick.
I had to use a two prong hub or gear puller. Not sure what it is, but I
bought it for six bucks at a local parts place and it worked great. The
pinion shaft had the requisite indentation at the end to acomodate the
pointed end of the stud on the puller, so it seems that this operation was
not unusual in any sense. I tried everything I knew prior to that. Even
tried using a pry bar on the ears of the flange and it was stuck.
Now that I've got the flange off, I'm befuddled by what I see. It appears
to be some sort of a flat 3/8ths inch metal ring that's flush with the
differential mount and covers most of the pinion seal underneath it. I see
no mention of this part at all in the catalogs. Maybe older pinion seals
were constructed differently than their replacements? In any case, I'm not
certain how to procede. I'm assuming that this flat, giant "washer" or
whatever it is needs to come out, but I'm not sure how to pull it out.
Maybe I can reverse the jaws of the gear puller I just used and yank it out
that way. I'm also unclear as to whether I need to put this thing BACK
after I get the new seal in, but I'm assuming YES. Strange that the parts
catalogs don't cover this piece.
Take care and thanks.
Jeff
----- Original Message -----
From: Bowen, Patrick A RP2 <PABowen@sar.med.navy.mil>
To: 'Jeff McNeal' <jmcneal@ohms.com>; <spitfires@autox.team.net>
Sent: Saturday, June 24, 2000 4:34 PM
Subject: RE: Stuck -- need advice, please
> Jeff, I do believe that the 30+ years since your car was made has gotten
the
> best of you. I is simply stuck, there is nothing else holding it on.
> Trying tapping it from the sides and just pulling, increasing the strength
> of your tap until it comes. I would not be afraid to hit it halfway
> modestly, as long as you don't hit the pinion itself, there should be
> nothing you would harm.
>
> Patrick Bowen
>
> -----Original Message-----
> From: Jeff McNeal [mailto:jmcneal@ohms.com]
> Sent: Saturday, June 24, 2000 3:30 PM
> To: spitfires@autox.team.net
> Subject: Stuck -- need advice, please
>
>
>
> A special thanks to all who have lent their expertise to my pinion seal
> replacement in the rear end of my Mk3.
>
> I've run into an obstacle that I'm really not sure how to deal with.
>
> I have successfully removed the casellated pinion nut -- but the flange
> doesn't seem to want to budge! Nobody mentioned this as something to
watch
> out for. I don't want to damage the flange by beating on it, but I don't
> know how I'm going to get it off!
>
> Any suggestions would be apprecated. Thanks again.
>
> Best wishes,
>
> Jeff in San Diego
>
> '67 RHD Spitfire Mk3 aka "Mrs. Jones"
> Jeff's Classic '67 Spitfire Mk3 site & Vintage Spitfire Webring
> http://www.ohms.com/spitfire/spitfire.shtml
> home of the NEW Totally Triumph Auction
> "By Triumph enthusiasts, for Triumph enthusiasts"
> http://www.ohms.com/cgi-bin/TRauction.cgi
> and... The Triumph Autos/Parts Wanted Listings
> http://www.ohms.com/cgi-bin/TRwanted.cgi
> ...plus a few other surprises!
>
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
>
>
|