Bob,
ISTR that my heat shield is mounted directly onto the inlet manifold, on the
studs which the carbs sit on. The sequence is
manifold-gaskets-heatshield-gaskets-carbs. The contents of a "head gasket set"
which I got seemed to confirm that this was correct - there were four gaskets of
the correct size/shape to fit over the carb bolts. But it's been a while, so I
may be wrong.
Dean
---------------
Date: Sat, 20 May 2000 07:49:08 -0500
From: "R.D. Waid" <msp01091@isd.net>
Subject: Heat Shield Mounting
I have a cookie sheet to use to make a heat shield for the twin SU setup on my
retrofitted Mark IV. How have you other heat shielders mounted your creations on
the engine?
Thanks in Advance,
Bob Waid
71 Mark IV, FK4081L
|