I am going to fabricate a plate made fro .040 or .051 sheet aluminum bu cutting
holes that align with the ports and bolt holes where
the carbs meet the manifold. That will secure it and allow the metal to b bent
to fit the gap between the intake and exhaust
manifolds.
Joe
"R.D. Waid" wrote:
>
> I have a cookie sheet to use to make a heat shield for the twin SU setup on my
> retrofitted Mark IV. How have you other heat shielders mounted your creations
>on
> the engine?
>
> Thanks in Advance,
> Bob Waid
> 71 Mark IV, FK4081L
|