Bowley, Glenn (GC CT) wrote:
>
> I had a question about this bolt size.
> I'm going to be removing my emissions "stuff" since my '75 does not have to
> go through emissions anymore (>=25 years old vehicles are exempt in CT.) My
> question is what size bolts can I use to plug the injection ports, are they
> pipe threads, or straight threads?
Just in case this somebody would remove the antipollution junk - I know
the
bolts that hold seatbelts into carbodies is the same thread and bolt size. They
are
straight thread.
Since there is a seat at the bottom of the hole in the head, I intend
to
machine the ends of the bolts off so they are shorter, and fit TIGHT, (even
perhaps with
copper washers) into that hole.
Cheers, Fred
--
Fred & Wendy Griffiths
Calgary, Canada
mailto: griffco@cadvision.com
http://www.cadvision.com/griffco/index.htm
|