Sam,
According to the instructions that came with my Crane (nee Allison)
ignition, there is supposed to have a ballast resistance wither internal
to the coil or externally in the form of a ceramic resistor or
resistance wire. It cautions against removing the resistance or
installing a non ballast coil where one is used.
Regards,
Joe
Sam Gentry wrote:
>
> I just discovered that my 80 spit with an Allison after market electronic
> ignition has NOT had the ballast resistor bypassed. This means that the
> 12V coil AND the ignition module are running on 8V. I am almost sure that
> the ballast should be bypassed and that both the coil and the module should
> be getting 12V. Can someone with an Allison Ignition(and maybe the
> instructions) confirm this?
>
> Sam
--
"If you can't excel with talent, triumph with effort."
-- Dave Weinbaum in National Enquirer
|