In message <99Feb13.120342nzdt.13446@gateway.nthshore.govt.nz>you write:
>Hi Dave,
>
>Problem is compressing the sping to get the circlip off. You can build a
>tool to do this out of 1/4" steel and a couple of 5/16" bolts. You make
>up two "C" shaped washers about 2" in diameter from 1/4" steel and drill
>a hole each side. Put a 'washer' each side of the spring, put the bolts
>through and then tighten to compress the sping.
>
Hi Peter, thanks for your reply. But I've already gotten the clip off
the only thing of the shaft is the barrel assembly. Does the barrel
just slide off the shaft? I tired pulling on it and it seems to be
stuck. Should I pull on it a little harder?
Dave |\ | | |
Dave Chu \/ \/ | /| | |
Dept. of Elec. & Comp. Eng. |/ | | |
Concordia University Voice:(514)848-3115 Fax:(514)848-2802
1455 de Maisonneuve W. H961 Email:dave@ece.concordia.ca
Montreal, Quebec, Canada H3G 1M8 http://www.ece.concordia.ca/~dave/addr.html
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
|